•This product is NOT a substitute for direct supervision of your baby. Check your baby’s activities at regular intervals. Monitoring of premature babies, or those considered to be at risk, should always be carried out under the supervision of a health professional.
•Always place both the Nursery Unit and Parents’ Unit on a flat surface in an upright position and allow for proper ventilation.
•Avoid damage to the Sensor Pad cord and to the adapter cords. Route cords so that they are not likely to be walked on or pinched by items placed on or against them.
•Route sensor pad cord only below crib matress and out of reach of children.
•Use ONLY AAA (LR03) batteries (not included) and/or the AC adapters provided for the Parents’ Units.
•During long periods of
•This monitor uses public airwaves to transmit signals. The Parents’ Unit may pick up signals or interference from other nursery monitors in your area. Your monitor may even be picked up by other households. To protect your privacy, make sure both units are turned off when not in use. If you experience interference, change the channel on both units.
•When the monitor is in use, do not use a crib mobile or other crib accessories that may produce vibrations. Other sources of vibrations may include fans, washing machines, loud music, etc. These sources of vibration may interfere with the performance of your Angelcare® monitor and the alarm will not sound if it continues to detect any movement other than your baby’s. Be sure all vibration sources are eliminated before using the monitor.
•You may experience false alarms for several reasons. The most common reason is the Nursery Unit has not been turned off after you have removed your baby from the crib. Another reason is the Sensor Pad has not been placed under the mattress properly. Be sure the Sensor Pad is on a flat, firm surface with the turquoise side facing up.
The sensitivity level may also need to be adjusted. Refer to the Movement Sensitivity Adjustment section on Pg. 11.
•Always be sure to immediately check on baby whenever an alarm sounds.
•Your monitor can be used in any crib that is stationary and designed to safely hold a baby. If your crib has a spring or slat base you will need to place a piece of Masonite board under the Sensor Pad. This support must be at least 13 inches long on all four sides and 1/4 inch thick. Only use your Angelcare® monitor in a stationary sleeping environment such as a crib where the Sensor Pad can rest on a completely flat, firm surface.
3
