Graco PM-1373AD 32

ADDITIONAL INFORMATION (continued)

Seat Pad and Armrest Pads:

Machine-wash separately on gentle cycle and drip dry.

Harness Straps:

Surface wash only with mild soap and damp cloth.

If harness straps are frayed or heavily soiled, they MUST be replaced.

Shell:

Wipe with mild solution of soap and water. Avoid wetting labels.

Never use “household detergents”: they can weaken plastic.

Buckle:

Rinse buckle with warm water. DO NOT use household detergents. Never lubricate buckle.

WARNING

Prevent serious injury or death:

•Buckle must be properly latched.

•Periodically inspect and clean buckle to remove objects or debris that could prevent latching.

Cup Holder:

Wash cup holder in warm water and mild soap.

Contents

Page Page MUST DO NOT use it again DO NOT With Harness System: Without Harness System: NOT DO NOT To avoid burns, always check before putting child in car seat With Harness System Without Harness System forward-facing (fig. a) HINT: (fig. b) (fig. c) Page To prevent serious injury or death: •Never place vehicle belt in front of child when using harness system must above (fig. a) Page Shoulder belt DO NOT use shoulder belt loose or positioned under child’s arms or armrests •Never use a vehicle “lap-only”belt across front of child •Vehicle belts MUST lay flat against child and MUST not be twisted MUST Page 1Harness Tie: 2Buckle: 3Tether Strap (fig. b): Page 4 Harness Straps (fig. c): 5 Changing Harness Strap Slots: (fig. e) (fig. f) End of each strap must be at least Page Removal: Re-assembly: When re-assemblingharness system, be sure harness straps are not twisted Page Page Flip cannot can must not Page Seat Crease Page (fig. b - page 25) Pull 1/2 inch (1 cm) Page short Available on some models: Removing Seat Pads: CAUTION: Removing Armrest Pads: Removing Cup Holder: Tab Page with same way without Page Page 1 Fold instruction manual 2 Store behind headrest pad