Manuals / Brands / Baby / Car Seat / Graco / Baby / Car Seat

Graco PM-1373AD short, Available on some models:

1 36

Download 36 pages, 1.4 Mb

ADDITIONAL INFORMATION (continued)

❃Tether Storage

For storage of tether hook if not used with a belt position booster:

•Adjust tether strap length so hook end is as short as possible.

•Roll loose end of strap up.

•Place rolled up strap on top of adjuster and place rubber band around bundle.

❃Cup Holder

Available on some models:

•Locate slot in armrest and armrest pad on either side of car seat.

•Snap cup holder into slot of armrest.

Contents

Page Page MUST DO NOT use it again DO NOT With Harness System: Without Harness System: NOT DO NOT To avoid burns, always check before putting child in car seat With Harness System Without Harness System forward-facing (fig. a) HINT: (fig. b) (fig. c) Page To prevent serious injury or death: •Never place vehicle belt in front of child when using harness system must above (fig. a) Page Shoulder belt DO NOT use shoulder belt loose or positioned under child’s arms or armrests •Never use a vehicle “lap-only”belt across front of child •Vehicle belts MUST lay flat against child and MUST not be twisted MUST Page 1Harness Tie: 2Buckle: 3Tether Strap (fig. b): Page 4 Harness Straps (fig. c): 5 Changing Harness Strap Slots: (fig. e) (fig. f) End of each strap must be at least Page Removal: Re-assembly: When re-assemblingharness system, be sure harness straps are not twisted Page Page Flip cannot can must not Page Seat Crease Page (fig. b - page 25) Pull 1/2 inch (1 cm) Page short Available on some models: Removing Seat Pads: CAUTION: Removing Armrest Pads: Removing Cup Holder: Tab Page with same way without Page Page 1 Fold instruction manual 2 Store behind headrest pad