Graco PM-1373AD 25

VEHICLE SEAT BELTS (continued)

❃Combination Lap/Shoulder Belt with Locking Latch Plate

With Harness System:	Flip
With Harness System:
OK to use. Follow vehicle owner’s manual for
specific instructions on how to use vehicle seat
belts.
The locking latch plate on some seat belts may	(fig. b)
The locking latch plate on some seat belts may
slip and loosen after being buckled on car seat if
positioned at a certain angle. If this happens,
flip the latch plate over (fig. b) and re-buckle.
Test installation again to see if this works. If
not, move car seat to another seating position.
Without Harness System:
OK to use. Follow vehicle owner’s manual for
specific instructions on how to use vehicle seat
belts.

Contents

Page Page MUST DO NOT use it again DO NOT With Harness System: Without Harness System: NOT DO NOT To avoid burns, always check before putting child in car seat With Harness System Without Harness System forward-facing (fig. a) HINT: (fig. b) (fig. c) Page To prevent serious injury or death: •Never place vehicle belt in front of child when using harness system must above (fig. a) Page Shoulder belt DO NOT use shoulder belt loose or positioned under child’s arms or armrests •Never use a vehicle “lap-only”belt across front of child •Vehicle belts MUST lay flat against child and MUST not be twisted MUST Page 1Harness Tie: 2Buckle: 3Tether Strap (fig. b): Page 4 Harness Straps (fig. c): 5 Changing Harness Strap Slots: (fig. e) (fig. f) End of each strap must be at least Page Removal: Re-assembly: When re-assemblingharness system, be sure harness straps are not twisted Page Page Flip cannot can must not Page Seat Crease Page (fig. b - page 25) Pull 1/2 inch (1 cm) Page short Available on some models: Removing Seat Pads: CAUTION: Removing Armrest Pads: Removing Cup Holder: Tab Page with same way without Page Page 1 Fold instruction manual 2 Store behind headrest pad