INSTALLATION

CHECK FOR DAMAGE

Check unit for any damage that may have occurredin shipping. Any damageshouldbenotedandthe carrier notified immediately.

CONNECT TO WATER SUPPLY

Refer to Parts Drawing on page 9.

ii,..- ...*.

.. :'>, ,.. ' .,.. , ..'i

ELECTRICAL SERVICE

 

connection to water supply.

 

 

The 1020E model comeswith an electric starter box

Do not exceed16O0F(7O0C)watertemperaturetothe

which isnotattachedtothe

unit. It is up tothe

installertowirethemotortothestarterandthe

pump in a direct supply system.

starter to the powersource.

 

Attach lidto tank by drilling four holesintank and use

The electrical service required for the1020E is 230V

screws, bolts and washers provided.

/6Ocycle / 50Amp / 3 phase. An optional 460V/ 60

cycle / 25 Amp / 3 phase service may be usedwith

Connectahosewithatleast3/4in.(ISmm)l.D.frOm

special instructions from manufacturer.

your water supply to the 3/4 in. garden hose fitting

 

on the water tank.

 

Refer to instrucfion manual for the wiring diagram on

 

page 4. Be sure that all wiring is properly grounded

Connect tank and pump with 3 / 4 in. I.D. hose and

andaccordingtoalllocalandnationalelectrical

clamps provided with the unit.

 

codes.

Place one endof hose on hose barbbottomat

of water

INSTALL SPRAY GUN

tank.Place theotherend of hose onhosebarb at

 

pump inlet. Clamp each end with,hose clamp. Pump

Connect the spray hose to the spray gun by inserting module and water tankshouldbeasclose togetheras

the pin fitting at the end of the hose into the quick

possible.Amaximumdistance of 5 ft. isrecomm-

coupler on the gun.

mended.

 

801-765 3

Page 3
Image 3
Graco Inc 800-076, 801-765 Installation Check for Damage, Connect to Water Supply, Electrical Service, Install Spray GUN