Basic American Medical Products, a division of GF Health Products, Inc. www.grahamfield.com 999-0831-190A Service Manual
14
Zenith aps seRies
:LUHIRUP:DOOVDYHU

%HQGIDFHVXSZDUG
'(7$,/$
6WDUWZLWK
WDEKHOG
KRUL]RQWDOO\
'(7$,/%
(QGZLWK
:DOOVDYHU
UHVWLQJRQ
IORRU

OPTIONAL WALLSAVER ADAPTOR BRACKET INSTALLATION TO

USE WITH TRENDELENBERG/REVERSE TRENDELENBERG FEATURE

STEP 2. WALLSAVER

ASSEMBLY

1. Position the Wireform Wallsaver
(Part 999-0844-180) with bent
end facing upwardand tab ends
facing inward as shown at right.
2. Gently squeeze the tab ends of
the wallsaver inward toward the
center of the wallsaver and, hold
-ing the tabs parallel with the
slots in the caster bases (See
DETAIL A), slide the tabs into the
slots while letting the wallsaver gently expand outward.
4. Turn the wallsaver downward until it rests on the floor (See Detail B).

STEP 3. WALLSAVER REMOVAL

1. To remove or move the WireformWallsaver to a new position, raise
the wallsaver off the floor untilthe end tabs are horizontal.
2. Squeeze the ends toward the center of the wallsaver until the
end tabs slide out of the caster base slots.

IMPORTANT:

WALLSAVER END NEAREST THE WALL MUST FACE UPWARD
AS SHOWN FOR WALLSAVER TO SEAT PROPERLY IN SLOTS.

STEP 1. BRACKET

INSTALLATION
1. Remove the tall Lock Nut (#1)
from the head end of both the
right and left-hand caster bases.
2. Position the two saddle
adaptor brackets (#2
- 999-0831-002) so
that the ends with
slots face away from
the bases as shown.
3. Lower the brackets
onto the caster bases,
aligning holes in brackets
with caster stems.
4. Secure brackets to caster bases
using short Nylon Lock Nuts (#3
- 100-6744-002) included in your
adaptor bracket bag/kit.
3
2
3
2
1
1

NOTE: MOUNTING OF THE ADAPTOR

BRACKETS IS ONLY NECESSARY IF YOU

PLAN ON USING THE TRENDELENBERG/

REVERSE TRENDELENBERG FEATURE.

Finish with
Wallsaver
resting on
floor