$OLJQ
$UURZV
3KLOOLSV6FUHZV
DWWDFK6KURXG
6WDII&RQWURO
$VVHPEO\IURP
LQVLGHRIERDUG
6WDII&RQWURO
$VVHPEO\
6KURXG
&DEOH&RYHU
)RRW%RDUG
ZLWKFXWRXW
&DEOH7LH
6WDII&RQWURO
$VVHPEO\
FDEOHWR
PRXQWLQJWXEH
)227(1'
/RRS0DOH6WDII&RQURO&DEOH
DQGFDEOHWLHWKURXJKPRXQWLQJ
WXEHKROHZLWK)HPDOH6WDII
&RQWURO&DEOH
)HPDOHHQGRI6WDII&RQWURO
$VVHPEO\&DEOHSOXJVLQWR7&DEOH
(QGRI'RXEOH7&DEOHDWIRRWHQG*UH\
7UXQVRQHLWKHUVLGHRI6HDW3DQ
IRUDWWDFKLQJ\RXU+DQG&RQWUROOHU
/RFNLQJ(QG&DSRQ'RXEOH7&DEOH
Basic American Medical Products, a division of GF Health Products, Inc. www.grahamfield.com 999-0831-190A Service Manual
11
Zenith aps seRies

PLUGGING IN THE FOOTBOARD NURSE/STAFF CONTROL

STEP 1 - ATTACHING THE FOOTBOARD
The APS 9000 bed features a Nurse/Staff Controller in the footboard, however the board is ordered separately with your
bed because of the variety of board styles available. If ordered at the same time as the bed, the Staff Control Assembly
and Shroud Cover will be pre-installed to the Footboard at the manufacturing factory.
STEP 2 - CONNECTING YOUR CABLES
Please refer to DETAIL A shown below.
a. If the Staff Control Assembly is not installed at the
factory you will need to first attach it to the footboard.
b. With the cutout side of the footboard facing outward
as shown, insert the staff control cable through the
large round hole.
c. With text right-side-up, insert the staff control
assembly into the cutout slot on the footboard
and attach to the board using the two outside
small holes and two screws from your staff
control hardware kit.
d. Attach the Shroud Cover over the cable on the
inside of the board using the four remaining
screws from your kit.
e. Insert the T-Cable end (extending out the
foot end with phone jack) into the round
plug, making sure the phone jack is
seated correctly inside the female plug
(arrow to arrow - see DETAIL B.)
f. Screw on the round lock cap onto
the Staff control’s female plug to
secure (see DETAIL B).
g. IMPORTANT:
Make sure to tie
off the staff control
cable to the foot-
board mounting
tube with a cable
tie as shown.
DETAIL A:
CLOSEUP OF STAFF
CONTROL CABLE CONNECTION
DETAIL B:
MAKE SURE LOCK
END CAPS ARE
SCREWED ON
SECURELY

SEE PAGE 10 OF THIS

MANUAL FOR PROPER

ASSEMBLY OF ELBOW

MOUNTING BRACKETS

(TUBES) & FOOTBOARD

Loop Male Staff Control Cable
and cable tie through mounting
tube hole with Female Staff
Control Cable.