Graham Field 9000APS Standard Wireform Wallsaver Installation, Wallsaver Assembly, Removal

Zenith aps seRies

STANDARD WIREFORM WALLSAVER INSTALLATION

STEP 1. WALLSAVER ASSEMBLY

1.Position the Wireform Wallsaver (Part 999-0844-180)with bent end facing upward and tab ends facing inward as shown at right.

2.Determine the position desired (See bottom of page).

3.Gently squeeze the tab ends of the wallsaver inward toward the center of the wallsaver and, holding the tabs parallel with the slots in the caster bases (See DETAIL A), slide the tabs into the slots while letting the wallsaver gently expand outward.

4.Turn the wallsaver downward until it rests on the floor (See Detail B).

HEAD END

:LUHIRUP:DOOVDYHU



%HQGIDFHVXSZDUG

	'(7$,/B$	Finish with
		Wallsaver
6WDUWZLWKWDEKHOG		resting on
KRUL]RQWDOO\		floor

'(7$,/B%	STEP 2. WALLSAVER
	REMOVAL
	1. To remove or move the Wireform
	Wallsaver to a new position, raise
	the wallsaver off the floor until
	the end tabs are horizontal.
	2. Squeeze the ends toward the
	center of the wallsaver until the
	end tabs slide out of the caster
	base slots.

STEP 2. WALLSAVER

POSITIONS

1.The APS 9000 wallsaver features

3 positions for easy reconfiguration - 76”, 80”, and Trapeze (if you use Trendelenberg/Reverse Trendelen- berg positions please see optional adaptor brackets on next page).

2.For 76” beds, position the wallsaver ends in the caster base slots closest to the FOOT end of the bed. For 80” beds, position the wallsaver ends in the MIDDLE slots on the bases.

3.If you have an optional Trapeze unit on a 76” bed, position the wallsaver ends in the MIDDLE slots on the caster bases. For 80” beds position wallsaver in slots closest to HEAD.

76” Bed Wallsaver Position w/o Trapeze

FOOT END

76” Bed Wallsaver
Position w/ Trapeze or	80” Bed Wallsaver
80” Bed w/o Trapeze	Position w/ Trapeze

HEAD END

			13
Basic American Medical Products, a division of GF Health Products, Inc.	www.grahamfield.com	999-0831-190A Service Manual