10
12
13
14
15
16
17
47
99
“MAC Address”
WAN Port Web Access
Firmware Server IP Address
Configuration Server IP Address
Upgrade Protocol
Firmware Version
Firmware Upgrade
“Direct IP Calling”
“RESET”
“Invalid Entry”
•
Announces the Mac address of the unit.
Press “9” to toggle between enable / disable
Announces current Firmware Server IP address. Enter 12 digit new IP address.
Announces current Config Server Path IP address. Enter 12 digit new IP address.
Upgrade protocol for firmware and configuration update. Press “9” to toggle between TFTP / HTTP
Firmware version information.
Firmware upgrade mode. Press “9” to toggle among the following three options:
-always check
-check when pre/suffix changes
-never upgrade
Enter the target IP address to make a direct IP call, after dial tone. (See “Make a Direct IP Call”.)
Press “9” to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
Five Success Tips when using the Voice Prompt
1.“*” shifts down to the next menu option
2.“#” returns to the main menu
3.“9” functions as the ENTER key in many cases to confirm an option
4.All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26 should be key in like 192168000026. No decimal is needed).
5.Key entry can not be deleted but the phone may prompt error once it is detected
PLACING A PHONE CALL
PHONE OR EXTENSION NUMBERS
1.Dial the number directly and wait for 4 seconds (Default “No Key Entry Timeout”); or
2.Dial the number directly and press # (Use # as dial key” must be configured in web configuration).
Examples:
1.Dial an extension directly on the same proxy, (e.g. 1008), and then press the # or wait for 4 seconds.
2.Dial an outside number (e.g. (626)
Grandstream Networks, Inc. | Page 10 of 35 | |
| Firmware 1.0.0.39 | Last Updated: 03/2007 |
