Grandstream Networks, Inc. HT-386 User Manual Page 10 of 34
Firmware 1.0.3.64 Last Updated: 2/2007
BASIC OPERATIONS GET FAMILIAR WITH VOICE PROMPT
The HT–386 has a stored voice prompt menu for quick browsing and simple configuration. Currently, the
voice prompt menu and the LED button is designed for FXS Port 1 ONLY.
To enter this voice prompt menu, press the LED button or press “***” from the analog phone.
TABLE 4: HT-386 IVR MENU DEFINITIONS
Menu Voice Prompt Options
Main Menu “Enter a Menu Option” Press “*” for the next menu opti on
Press “#” to return to the main menu
Enter 01-06, 47, 86, 99 menu options
01 “DHCP Mode”,
“Static IP Mode”
Press “9” to toggle the selection
If using “Static IP Mode”, configure the IP address
information using menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information
comes from the DHCP server automatically after reboot.
02 “IP Address “ + IP address The current WAN IP address is announced
If using “Static IP Mode”, enter 12 digit new IP address.
03 “Subnet “ + IP address Same as menu 02
04 “Gateway “ + IP address Same as menu 02
05 “DNS Server “ + IP address Same as menu 02
07 Preferred Vocoder Press “9” to move to the next selection in the list:
• PCM U / PCM A
• G.723
• G.729
• G.726
• iLBC
12 WAN Port Web Access Press “9” to toggle between enable / disable
13 Firmware Server IP
Address Announces current Firmware Server IP address. Enter
12 digit new IP address.
14 Configuration Server IP
Address Announces current Config Server Path IP address. Enter
12 digit new IP address.
15 Upgrade Protocol Upgrade protocol for firmware and configuration update.
Press “9” to toggle between TFTP / HTTP
16 Firmware Version Firmware version information.
17 Firmware Upgrade Firmware upgrade mode. Press “9” to toggle among the
following three options:
- always check
- check when pre/suffix changes
- never upgrade