Great Dane GBKH2752S, GBKH2761S manual Troubleshooting, Cleaning and Repairing Plastic Surfaces

TROUBLESHOOTING

2.Slightly loosen five wheel nuts (A).

CAUTION: Avoid injury! The machine can fall or slip from an unsafe lifting device or supports.

•Use a safe lifting device rated for the load to be lifted.

•Lower machine onto jack stands or other stable supports and block wheels before servicing.

IMPORTANT: Avoid damage! Place jack stands under frame, not under transmission or engine, when raising or supporting machine.

3.Lift machine with a safe lifting device.

4.Remove wheel nuts.

5.Remove wheel and tire assembly (B).

Installing Rear Drive Wheels/Tightening Hardware:

1.Install new wheel and tire assembly.

2.Install and tighten wheel nuts in numbered sequence shown for safe wheel installation. Tighten alternately until recommended torque value is reached.

•Tighten nuts to 100 N•m (75 lb-ft). 3.Lower machine.

Cleaning and Repairing Plastic Surfaces

Your authorized dealer has the professional materials needed to properly remove surface scratches from any plastic surfaces, do not attempt to paint over marks or scratches in plastic parts.

IMPORTANT: Avoid damage! Improper care of machine plastic surfaces can damage that surface:

•Do not wipe plastic surfaces when they are dry. Dry wiping will result in minor surface scratches.

•Use a soft, clean cloth (bath towel, diaper, automotive mitt).

•Do not use abrasive materials, such as polishing compounds, on plastic surfaces.

•Do not spray insect repellent near machine.

1.Wash surface with clean water and a mild liquid automotive washing soap.

2.Dry thoroughly to avoid water spots.

Cleaning and Repairing Metal Surfaces

Cleaning:

Follow automotive practices to care for your vehicle painted metal surfaces. Use a high-quality automotive wax regularly to maintain the factory look of your vehicle’s painted surfaces.

Repairing Minor Scratches (surface scratch):

1.Clean area to be repaired thoroughly.

IMPORTANT: Avoid damage! Do not use rubbing compound on painted surfaces.

2.Use automotive polishing compound to remove surface scratches.

3.Apply wax to entire surface.

Repairing Deep Scratches (bare metal or primer showing):

1.Clean area to be repaired with rubbing alcohol or mineral spirits.

2.Use paint stick with factory-matched colors available from your authorized dealer to fill scratches. Follow directions included on paint stick for use and for drying.

3.Smooth out surface using an automotive polishing compound. Do not use power buffer.

4.Apply wax to surface.

Troubleshooting

Using Troubleshooting Chart

If you are experiencing a problem that is not listed in this chart, see your authorized dealer for service.

When you have checked all the possible causes listed and you are still experiencing the problem, see your authorized dealer.

Troubleshooting - 44