![](/images/new-backgrounds/1099863/99863101x1.webp)
ASSEMBLY
1.Remove and retain the two locknuts and cap screws securing the flanges at the rear of the seat frame to the machine.
2.Pivot seat frame (A) forward until it rests on the hinge stops.
3.Remove and retain the seat pivot shoulder bolts (B) and nuts.
4.Remove protective covers from seat screws.
NOTE: The seat mounting hardware is attached to the seat plate with tie straps.
5.Install seat (C) to the seat frame (A), using four
6.Connect wire harness to seat safety switch (E).
7.Secure front of seat frame to machine with seat pivot shoulder bolts and nuts, removed earlier. Tighten to 81 N•m (60
8.Secure rear of seat frame to machine with capscrews and locknuts, removed earlier.
Install ROPS
1.Support rear of bumper with wooden blocks or jack.
2.Loosen nut (A) securing the rear battery
3.Remove all bumper mounting bolts and retaining hardware except for the lower left cap screw (C) at each side of the machine. Discard any assembly washers, retain bolts and locknuts for later use.
4.Fold ROPS to the upright operating position and install lock pins (D) and spring pins (E).
Assembly - 49