Installing Your Unit (cont.)
7. Review hopper contents to make sure all parts are available:
Part # | Description |
W0600114 | Manual |
|
|
W0600073 | Rubber Pad Sheet |
|
|
W0600121 | Merchandiser Installation Sheet |
|
|
W0600012 | MSDS Sanitizer Sheet |
|
|
W0600159 | Warranty Registration Card |
|
|
W0890218 | Drip Tray Kit |
|
|
W0520094 | Hopper Cover |
|
|
W0480445 | Valve Handle |
|
|
W0631230 | Valve Spring |
|
|
* | Carb Tube |
|
|
* | Dispense Valve Plunger |
W0470076 | Lubricant |
|
|
W0631903 | Sanitizer Packets |
|
|
W0340022 | |
|
|
*Optional items specified when the unit is ordered.
8.Fill out Warranty Registration Card with the requested information and mail to Grindmaster Corporation.
9.Replace side panels.
10.Assemble the dispense valve following the instructions on page 9. The valve plunger, spring and retaining pin come in the small parts bag.
11.Be sure
12.Connect the power cord directly to a properly grounded DEDICATED 220V/60Hz, 15 Amp circuit. Do not use an extension cord.
!Do not alter or deform the plug in any way! Altering or deforming the plug may damage unit and will void warranty.
13.Remove the drip tray kit from the bubble wrap. Separate the parts and remove the protective coating. The drip tray is mounted on two screws that are located on the lower front of the freezer cabinet.
14.Place the key hole slot of the drip tray support bracket (W0471022) on to these screws and tighten the screws.
15.Angle the back of the drip tray surround bracket into the drip tray support bracket (W0471022) and lower bracket to lock it into place.
16.Place drip tray onto drip tray surround bracket.
17.Place the louvered drip tray insert into drip tray.
Model 3511 | Page 5 |
|
|