Consistency Adjustment
From time to time, it may become necessary to readjust the consistency setting (thickness) to compensate for variation between different mixes or to switch from one type of product to another. This adjustment is made as follows:
1.Disconnect electrical power.
!WARNING: Do not attempt to readjust the freezer until electrical power has been disconnected.
2.Remove right side panel (facing the freezer).
3.Use the adjustment screw, situated on the front of the drive motor mounting bracket to change product thickness. Turn the thumbscrew (3 full turns for red spring, 1 turn for yellow spring) to make a noticeable change in consistency. (See Figure K)
NOTE: Clockwise is for thicker product consistency and counter clockwise is for thinner product consistency. (See Figure L)
4.Reinstall the side panel, reconnect power.
5.Turn freezer to “ON” and allow it to freeze to desired consistency.
6.Check product. Repeat process until desired consistency is achieved.
NOTE: When making changes to a colder (thicker) setting, recheck consistency again after the compressor has cycled off. When adjusting
Mix Low Float
Carburetor
Mix Low Float
Figure J
Adjustment Screw
Figure K
Increase Thickness
(turn clockwise)
Decrease Thickness
(turn counterclockwise)
Figure L
Model 3511 | Page 7 |
|
|