Mounting Planer/ Moulder on Stand
The Model G0477 is a very heavy machine. Get assistance when lift- ing the planer/moulder onto the stand. Failure to comply can result is seri- ous personal injury!
Components and Hardware Needed: |
|
Hex Bolts | 4 |
Flat Washers 8mm | 8 |
Hex Nuts | 4 |
To mount the planer/moulder to the stand:
1.Position the assembled stand so that it is on a flat, level surface and is clear of nearby equipment or other obstructions.
2.With the help of an assistant, lift the planer/ moulder onto the stand.
3.Align the mounting holes in the base cast- ing of the planer/moulder with the mounting holes in the stand, as shown in Figure 8.
Mounting Hole
Figure 8. Mounting holes in base casting.
4.Fasten the planer/moulder to the stand using the M8-1.25 x 80 hex bolts, flat washers and hex nuts.
Dust Chute and Bag
DO NOT operate the Model G0477 without the dust collection bag installed. This plan- er/moulder creates substantial amounts of wood dust while operating. Failure to use the dust collection bag can result in short and
Components and Hardware Needed: | Qty |
Dust Chute | 1 |
Button Head Cap Screw | 1 |
Dust Collection Bag | 1 |
Bag Clamp | 1 |
Dust Chute Adapter | 1 |
Cap Screw | 1 |
To install the dust chute and bag: |
|
1.Fasten the dust chute on the fan cover using the button head cap screw.
2.Fit the dust chute adapter over the dust chute and fasten in place using the cap screw.
3.Slip the bag clamp over the neck of the bag, and fit the bag opening onto the dust chute adapter.
4.Close the clamp to fasten the bag onto the dust chute adapter.
5.Give the bag a slight tug to ensure it is secured tightly.
Note: If the clamp seems to be too loose or too tight when the clamp is engaged, it can be adjusted by rotating the clamping handle. Rotate the clamping handle clockwise to tighten the clamp or counterclockwise to loosen the clamp.
