Grizzly G0477 Setting Up Moulding Guide Fence, Adjusting Moulding Guide Fence, Edge Moulding

Setting Up Moulding

Guide Fence

Components and Hardware Needed:	Qty
Wing Bolts 1⁄4-20 x 11⁄4"	4
Flat Washers 1⁄4"	4
Cap Screw M5-.8 x 60	2
Flat Washer 5mm	2
Guide Fence Clamp	2

It is essential that you have a properly adjusted guide fence in place when moulding. Figure 22 on Page 22 features a plan for creating your own guide fence. We recommend using softwood or plywood for guide fence construction.

To fasten the guide fence to the planer/mould- er:

1.UNPLUG THE PLANER/MOULDER FROM THE POWER SOURCE!

2.Ensure that the threaded inserts indicated in Figure 22 on Page 22 are firmly in place.

3.Raise the planer/moulder headstock to its maximum height to provide working room.

4.Hand-fasten the guide boards to the base- board using the wing bolts and flat washers.

5.Fasten the baseboard to the table using the cap screws, flat washers and clamps, as shown in Figure 21.

Extension

Table

Clamp

Cap

Screw

Main

Table

Figure 21. Clamp installation.

Model G0477 15" Planer/Moulder

Adjusting Moulding

Guide Fence

To adjust the guide fences to fit a workpiece:

1.UNPLUG THE PLANER/MOULDER FROM THE POWER SOURCE!

2.Place the workpiece flush against the center guide.

3.Adjust the guide boards to fit the workpiece, allowing for smooth and even workpiece movement throughout the guide fence.

4.Fully tighten the wing bolts to fasten the guide boards in place.

Edge Moulding

Certain moulding tasks require the workpiece to be oriented vertically, and thus extra-tall guide boards are needed. Follow the plan shown in Figure 22 on Page 22, but increase the width of the center guide and the guide boards from 1⁄2" to to 1".

To prepare the guide fence for edge mould- ing:

1.UNPLUG THE PLANER/MOULDER FROM THE POWER SOURCE!

2.Replace the center guide and guide boards with extra-tall guides.

3.Follow Steps 2–4 of Adjusting Moulding Guide Fence on this page.

-21-