SECTION 4: OPERATIONS
Operation Safety |
| Safety Switch Key |
|
|
|
|
|
|
Damage to your eyes, lungs, and ears could result from using this machine without proper protective gear. Always wear safety glasses, a respirator, and hearing protection when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving machinery.
NOTICE
If you have never used this type of machine or equipment before, WE STRONGLY REC- OMMEND that you read books, trade maga- zines, or get formal training before begin- ning any projects. Regardless of the con- tent in this section, Grizzly Industrial will not be held liable for accidents caused by lack of training.
To prevent the machine from starting, remove the lockout key (Figure 10) from the paddle switch.
Figure 10. Removing key to disable switch.
Basic Operation
The basic steps of operating the planer/ moulder are as follows:
1.Put on safety glasses, ear protection and a respirator.
2.Unless your workpiece starts very flat, sur- face plane the workpiece on a jointer until it is flat.
3.Adjust the headstock height (see Page 18) so that the planing knives are slightly lower than your workpiece height to ensure the first cut is as light as possible.
4.Start the planer/moulder.
5.Place the flat side of the board down on the table, and feed the workpiece through the planer/moulder, making sure not to stand directly in front or behind the workpiece.
