Grizzly G0518 Beginning Assembly, Stand To Base, To attach the stand to the base

Beginning Assembly

This section will cover the basic assembly and adjustment instructions needed to begin opera- tion. Complete the assembly in the order provid- ed in this manual and then read the remaining portion of the manual before attempting any type of operation.

Your safety is important! Please follow the warnings below during this entire section:

Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.

!could occur if you con- nect your machine to theSerious personal injury

power source before you have completed the assembly process. DO

NOT connect the machine to the power source until instructed to do so.

Sharp edges on metal parts may cause person- al injury. Examine the edges of all metal parts before handling.

Stand To Base

To attach the stand to the base:

Attach the stand to the base with (4) M8-1.25 x 20 cap screws, (4) M8 flat washers, (4) M8 lock washers and (4) M8-1.25 hex flange nuts (Figure 5). Note–The lock washers should be installed between the flat washers and the head of the cap screws.

Stand

Fasteners

Base

Figure 5. Stand attached to base.

-14- G0518 Drum / Flap Sander