Installing Disc Table
To install the disc table:
1.Lay the table upside down and align the table support with the holes in the table.
2.Take three hex bolts out of the hardware bag and put a lock washer and a flat washer on each bolt.
3.Screw the hex bolts with washers through the table support and into the disc table as shown in Figure 5.
Figure 5. Bolting the table support to the disc table.
4.Insert the index pin shown in Figure 6 into the upper hole on the base and tighten the knob.
Index Pin
Figure 6. Inserting the index pin into the base.
Squaring Table
When the table tilt is set to 0˚, the table should be adjusted perpendicular to the sanding disc face.
To square the table:
1.Disconnect the machine from the power source!
2. Using a try square or machinist’s square, set one edge on the table surface and the other against the face of the disc as shown in
Figure 7.
!
Figure 7. Squaring disc table.
3.Loosen the lock knob and adjust the table angle until there is no gap between the disc face and the square.
4.Tighten the lock knob while holding the table perpendicular.
5.Place the angle measurement label on the base so the angle indicator points to 0˚.
|
|
|
|
|
|
|
|
|
|
|
|
G0547 Combo Sander | |||
