Grizzly G0547 Adjusting Belt Angle, Installing Back Stop, Installing Sanding Belt

Adjusting Belt Angle

To adjust the sanding belt angle:

1.Disconnect the machine from the power source!

2.Loosen the cap screw shown in Figure 11.

!

Figure 11. Raising the sanding belt bed.

3.Raise the sanding belt to the desired angle and tighten the cap screw.

Installing Back Stop

To install the back stop:

1.Screw a hex bolt, with a flat washer and a lock washer on it, through the back stop and into the hole shown in Figure 12.

2.Square the back stop as shown in Figure 12 and tighten the hex bolt.

Figure 12. Squaring the back stop

Installing Sanding

Belt

To install the sanding belt:

1.Disconnect the machine from the power source!

2.Loosen the belt tension by pulling out the tensioning lever shown in Figure 13.

!

Belt

Tensioning

Lever

Figure 13. Installing belt.

3.Slide the belt onto the drive drums as shown in Figure 13 and release the belt tensioning lever.

Note—make sure that the arrow on the inside of the sanding belt points the same direction as the belt rotation arrow on the machine.

-16- G0547 Combo Sander