Grizzly G0594 Replacing Blades, Replacing V-Belt, Tools Needed, To perform this procedure

Replacing Blades
Sharpen or replace the blades as soon as the
chipping performance begins to deteriorate, or if
you notice dings, chips, or cracks.
Tools Needed	Qty
Wrench/Socket 13mm	1
Hex Wrench 5mm	1
To perform this procedure:

1.TURN OFF THE MACHINE, ALLOW ALL MOVING PARTS TO COME TO A COM- PLETE STOP, AND DISCONNECT THE SPARK PLUG WIRE!

2.Remove the side cover plate (photo inset in Figure 11) to expose the blades.

Chipper Blade

Figure 11. Chipper blade.

3.Remove one blade, rotate the impeller, and remove the second blade.

4.Have the original blades professionally sharpened, or order a replacement set, then re-install the blades.

5.Replace the side cover plate and re-attach the spark plug wire.

Replacing V-Belt

Replace or tighten the V-belt	if	you notice the
motor running and the chipper blades are not
spinning.
Tools Needed		Qty
Wrench/Socket 13mm		1
To perform this procedure:

1.TURN OFF THE MACHINE, ALLOW ALL MOVING PARTS TO COME TO A COM- PLETE STOP, AND DISCONNECT THE SPARK PLUG WIRE!

2.Remove the pulley cover (photo inset in Figure 12).

Idler Pulley

Pulley

Cover

Figure 12. Replacing V-belt.

3.Loosen the idler pulley and roll the belt off of the pulleys (see Figure 12).

4.Install the new belt and adjust the idler pulley so the V-belt deflects approximately 3⁄8" when pushed with moderate pressure.

5.Replace the V-belt cover and re-attach the

spark plug wire.

G0594 Large Chipper/Shredder -15-