Figure 5. Positioning the hopper gasket.
4.Place the hopper on top of the gasket and line up all of the holes. Place rubber grom- mets and fender washers on two hex bolts, thread them through the holes nearest the motor and secure them with flat washers, lock washers, and lock nuts.
5.Line up the holes in the toolbox with the remaining holes in the hopper and secure them with the same combination of hex bolts, washers, and lock nuts as used in Step 4 (see Figure 6).
Figure 6. Attaching the hopper and toolbox.
6.Insert a Phillips head screw with a flat washer through each hole in the handles. Place three flat washers on each of the screws and insert the handle assembly into the holes in the hopper (see Figure 7). Secure the handles with a flat washer, lock washer, and lock nut on each screw.
Figure 7. Installing the handles.
7.Place the funnel over the studs in the side of the chipper/shredder and secure it with the remaining flat washers, lock washers, and lock nuts (see Figure 8).
Figure 8. Funnel installation.
8.Before operating, fill the motor with oil and gas according to the instructions in the Briggs & Stratton manual.
NOTICE
This chipper/shredder does not have oil in the motor when shipped. Add oil before operating the chipper/shredder, or the motor will seize.
G0594 Large Chipper/Shredder
