InventoryAssembly
After all the parts have been removed from the box, you should have the following items:
Inventory (Figure 3) | Qty | |
A. | Chipper/Shredder | 1 |
B. | Wheel Assembly | 2 |
C. | Hopper | 1 |
D. | Funnel | 1 |
E. | Hopper Gasket | 1 |
F. | Handles | 2 |
G. | Leg | 1 |
H. | Toolbox (Contents Not Shown) | 1 |
| 1 Pair | |
| 1 Pair | |
| 1 Pair | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
| 1 | |
|
|
| C |
|
| D |
|
|
|
|
| A |
|
|
|
|
| G |
|
| B |
|
|
|
|
| H |
|
|
|
|
| F | E |
| Figure 3. Model G0594 inventory. |
| ||
Hardware (Not Shown) |
| Qty | ||
• Hex Bolt | ............................... | 4 | ||
• | Rubber Grommets | 4 | ||
• Phillips Head Screw | 4 | |||
• | Fender Washers 8mm | 4 | ||
• | Lock Nuts | 11 | ||
• | Flat Washer 8mm | 27 | ||
• | Lock Washer 8mm | 11 | ||
In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expedi- ency, replacements can be obtained at your local hardware store.
G0594 Large Chipper/Shredder
The major components of this chipper/shredder have been assembled at the factory. Some minor assembly is required. The assembly process will use all the parts and hardware listed in the inven- tory.
DO NOT attempt to start this machine until all assembly has been completed. Serious personal injury and damage to the machine could occur.
To assemble the chipper/shredder:
1.Tip the chipper/shredder over and remove the four bolts shown in Figure 4. DO NOT turn the chipper/shredder over once it is full of oil and gas. The oil and gas will spill out.
Leg | Leg Bolts |
| |
Wheel |
|
Assembly |
|
Bolts |
|
Figure 4. Attaching the leg.
2.Attach the wheel assembly and the leg with the bolts that were removed in Step 1.
3.Set the chipper shredder upright and set the hopper gasket around the chute as shown in Figure 5.
