Assembly

 

Test Run

 

 

 

 

 

 

To install the tool rest:

1.Turn the release lever on the tool rest base so it does not interfere with assembly.

2.Thread the tool rest lock handles into the tool rest base (Figure 6) until the threaded ends of the handles are flush with the inside of the shaft.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Tool Rest

 

 

 

 

 

 

 

Base

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Lock

 

 

 

 

 

 

 

 

Lock Handle

 

 

 

 

Handle

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Release Lever

 

 

 

 

 

 

 

 

 

 

Figure 6. Tool rest lock handles installed onto

tool rest base.

3.Insert the tool rest into the shaft and turn the handles to lock it as shown in Figure 7.

Figure 7. Tool rest installed.

4.Install the optional bed extension, Model G0625 (Page 21). Refer to the instruction sheet included with the bed extension.

-12-

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following: 1) The motor powers up and runs correctly, and 2) the safety paddle switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 24. If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure that you have read the safety instructions at the beginning of this manual and that the machine is setup properly.

2.Connect the machine to the power source.

3.Flip the paddle switch up to turn the machine ON. Make sure that your hand stays poised over the switch in case you need to quickly turn the machine OFF.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

4.Turn the machine OFF.

5.Remove the safety key and attempt to turn the machine ON.

—If the machine starts, stop it. The switch disabling feature is not working. This safety feature must work properly before proceed- ing. Call Tech Support for help.

—If the machine does not start, the switch disabling feature is working.

G0624 10" Benchtop Lathe

Page 14
Image 14
Grizzly G0624 owner manual Assembly Test Run, To install the tool rest, To test run the machine