Grizzly G0624 owner manual Installing/Removing Spur Center, Installing/Removing Live Center

Installing/Removing

Spur Center

The spur center installs into the headstock spin- dle with a taper fit.

To install the spur center:

1.UNPLUG LATHE FROM POWER!

2.Insert the tapered end of the center into the spindle, and push it in quickly and firmly (see Figure 12).

Figure 13. Removing spur center using the

knock out bar.

Figure 12. Inserting spur center into spindle.

3.Check that the center is securely installed by giving it a quick tug. (A properly installed center will not pull out by hand.)

To remove the spur center with the knock-out bar:

1.UNPLUG LATHE FROM POWER!

2.Hold a clean rag under the spindle or wear a glove to catch the center when you remove it.

3.Using the knock-out bar, tap the center from the outside end of the spindle (as shown in Figure 13) and catch the center as it falls out.

G0624 10" Benchtop Lathe

Installing/Removing

Live Center

To install the live center:

1.Loosen the quill lock handle (if locked) approximately half a turn counterclockwise.

2.Rotate the quill handwheel clockwise until the tailstock quill protrudes out of the tailstock housing about 3⁄4''.

3.Insert the live center, as shown in Figure 14, and push firmly.

Quill Lock Handle

Quill

Quill

Handwheel

Figure 14. Installing live center in tailstock.

4.Tighten the lock handle.

-15-