Grizzly G0631 owner manual Test Run, To test run the downdraft table

Test Run

Once the assembly is complete, test run your downdraft table to make sure it runs properly and verify safety features are in working order.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Page 20.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the downdraft table:

1.Ensure that anyone in the vicinity of the downdraft table, including yourself, is wear- ing safety glasses.

2.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is set up properly.

3.Connect EACH motor to a dedicated 110V circuit (see CIRCUIT REQUIREMENTS, Page 8).

4.Flip both paddle switches up to turn the downdraft table ON. Make sure that your hand stays poised over the switches in case you need to quickly turn the machine OFF.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power before investigating or correcting potential problems.

5.Turn the downdraft table OFF.

6.Remove the safety keys (Figure 12) and attempt to turn the machine ON.

—If the machine starts, stop it. The switch disabling feature is not working. This safety feature must work properly before proceed- ing. Call Tech Support for help.

—If the machine does not start, the switch disabling feature is working.

Figure 12. Disabling switch.

G0631 79" x 28" Downdraft Table -15-