Grizzly G0671, G0673, G0672 owner manual Collector mounted to impeller Housing

4.Attach the four casters to the legs by thread- ing them into the bottom of the legs, as shown in Figure 15.

Caster

Leg

m)

Figure 15. Attaching casters.

5.With assistance, turn the entire assembly over so that the casters rest on the floor.

6.Use eight 5⁄16"-18 x 1" hex bolts, (16) 5⁄16" flat washers, and eight 5⁄16"-18 hex nuts to attach each collector to the impeller housing with a rubber gasket between the components, as shown in Figure 16.

5⁄16" Flat Washers	Impeller
Collector	housing
	5⁄16"-18
	Hex Nut
5⁄16"-18 x 1"
Hex Bolt
Rubber Gasket

Figure 16. Collector mounted to impeller

housing.

Note: The Model G0673 is a three-phase machine. If it is wired out of phase, the machine may not function properly. Proceed to Test Run on Page 25 to determine if your machine is wired in phase, then proceed to Step 7.

The Models G0671 and G0672 are single phase and cannot be wired out of phase. For these models, continue below.

7.Attach the inlet to the top of the impeller housing with the #10-24 x 3/8" Phillips head screw, as shown in Figure 17.

Phillips

Head Screw

Figure 17. Inlet mounted on impeller housing.

-22- G0671/G0672/G0673 Dust Collector