Model g0690/g0691 (Mfg. 11/10+) -31-
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following:
1) the motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on page 63.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Connect the machine to the power source.
4. Verify that the machine is operating correctly
by turning the machine ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
5. turn the machine OFF.
6. insert the switch disabling pin through the
green oN button, as shown in Figure 39.
7. press the green oN button to test the dis-
abling feature on the switch.
—if the machine does not start, the switch
disabling feature is working as designed.
—if the machine starts, immediately stop the
machine. the switch disabling feature is
not working correctly. this safety feature
must work properly before proceeding with
regular operations. Call tech support for
help.
Figure 39. switch disabling pin inserted into oN
button.
pin
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
however, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure that the
cutting you do with your new machine is safe and
accurate.
step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Adjustments that should be verified:
1. Blade tilt stop accuracy (page 65).
2. Miter slot parallel to Blade (page 67).
3. spreader/riving Knife alignment (page 68).
Recommended Adjustments