Model g0690/g0691 (Mfg. 11/10+) -2 7-
5. adjust the extension table so it is flat (both
flush and parallel) with the main table, using
a long straightedge (similar to the method
shown in Figure 25). this can be done by
loosening the mounting bolts and adjusting
the feet up/down as needed.
6. tighten the extension table mounting bolts,
and tighten the hex nuts on the feet up
against the legs so they will not move.
3. slide the miter gauge into the t-slot on the
left hand side of the blade.
Magnetic Switch
1. install the magnetic switch onto the bottom
left hand side of the front rail using two M6-1
x 12 hex bolts, 6mm lock washers, and 6mm
flat washers, as shown in Figure 29.
Figure 29. Magnetic switch installed.
2. secure the top of the switch to the rail with
an M6-1 x 12 phillip head screw, 6mm lock
washer, and flat washer.
Saw Blade
1. remove the table insert by unscrewing the
screw that fastens it to the table.
2. raise the arbor all the way up and set the
blade angle at 0ยบ.
3. remove the arbor nut and arbor flange from
the arbor, slide on the included 10" saw
blade, making sure the teeth face the front
of the saw, then install the arbor flange and
arbor nut onto the blade.
4. put on a pair of heavy leather gloves and
use the included arbor wrenches to tighten
the arbor nut (turn clockwise to tighten), as
shown in Figure 30.
Fence & Miter Gauge
1. attach the fence handle to the fence and
thread the rear rail foot into the bottom of the
fence (see Figure 27).
Figure 27. Fence assembled.
2. place the fence on the rails on the right hand
side of the blade.
Note: Make sure the cam foot contacts the
cam on the fence lock handle before you
place the fence on the rail, otherwise the
fence will not lock onto the rail tube.
Figure 28. Fence installed on rails.
handle
rear rail Foot
Cam Cam
Foot