Model g0690/g0691 (Mfg. 11/10+) -23-
Assemblyassembly steps are the s ame for the Model
g0690 and g0691 except where noted. assembly
consists of installing minor components, the exten-
sion wings, front and rear rails, extension table,
and the legs (Model g0691 only).
To assemble the table saw:
1. pull the magnetic switch out of the saw cabi-
net and install the door by inserting the door
pins into the hinge sockets on the cabinet
(see Figure 11).
Figure 11. door installed.
hinge
socket
2. place the included 5 x 5 x 40 key in the
handwheel shaft and slide the handwheel
onto the shaft on the front of the table saw.
use the included 2.5mm hex wrench to tight-
en the set screw (see Figure 12) on the side
of the handwheel until it is secure.
Figure 12. handwheel set screw.
3. thread the handwheel lock knob into the cen-
ter of the handwheel and tighten, then install
the handle into the handwheel using a 14mm
wrench (see Figure 13).
Figure 13. handwheel installed.
lock Knob
4. remove the shipping brace (see Figure 14)
using a 17mm wrench and a pair of needle
nose pliers. reinstall the M10-1.5 x 25 hex
bolt, flat washer, hex nut and the cotter pin,
and save the shipping brace.
Figure 14. shipping brace location.
handle