|
|
Components and Hardware Needed: | Qty |
1 | |
To install the |
|
1.UNPLUG THE BANDSAW!
2.Lift the motor and slip the
Figure 15. V-belt tension knob.
Figure 14. Installing V-belt.
3.Lower the motor, apply downward pres- sure on the motor base and adjust the V- belt tension knob to tension the belt (see Figure 15). Apply enough tension so the belt deflects about 1⁄2" with moderate pressure when pinched together at the points shown in Figure 16.
Figure 16. V-belt in place and tensioned.
4.Close the pulley cover.
G1010 4" x 6" |
