Grizzly G1010 Stand Assembly, Components and Hardware Needed Qty, To assemble the stand

Stand Assembly

Components and Hardware Needed:	Qty
Carriage Bolts 5⁄16"-18 x 3⁄4"	14
Hex Nuts 5⁄16-18	14
Flat Washers 5⁄16"	14
Legs	4
Long Leg Braces	2
Short Leg Braces	2
Upper Stand Support	1
Tool Tray	1
Axle	1
Wheels	2
Cotter Pins	4
Transport Handle	1
Rubber Feet	2
Flat Washers 3⁄8"	4
Hex Nuts 3⁄8"-16	4
Flat Washers 5⁄8"	4
To assemble the stand:

1.Attach the short leg braces and then the long leg braces to the legs with carriage bolts, washers and hex nuts as shown in Figure 5.

Note: At this time, tighten with a 12mm wrench or socket just enough to secure the parts. Final tightening will take place when the stand is fully assembled.

Figure 5. Leg braces.

-16-

2.Secure the upper stand support to the inside of the legs using the carriage bolts. Start by securing the upper carriage bolt highlighted in Figure 6.

3.Attach the tool tray to the legs as shown in Figure 6. One side of the tool tray will share the lower carriage bolt of the upper stand support.

Upper Stand

Support

Leg

Tool Tray

Figure 6. Upper stand support and tool tray.

4.Slide the axle through the two holes at the bottom of the legs as shown in Figure 7.

5.Slide the wheels onto the axle with two 5⁄8" flat washers on either side of the wheel.

6.With a pair of pliers, insert a cotter pin through each hole at the end of the axle and bend back one end of the cotter pin to keep the wheel in place.

Figure 7. Axle and wheels.

G1010 4" x 6" Metal-Cutting Bandsaw