Thickness Scale, To Adjust the Scale | Grizzly G1021 specs

Thickness Scale

The thickness scale, located below the handwheel, can be adjusted for accuracy. However, the machine must be operated to adjust the thick- ness scale. Follow the directions in the Operations Section for test running before attempting to make these adjustments.

TO ADJUST THE SCALE:

1.Adjust the table height to the approximate thickness of your test lumber. Measure the lumber with calipers to determine its exact thickness.

2.Move the table to 1/16" under the thickness of your lumber and feed your test board through the planer.

3.Turn the handwheel one half rotation and run the board through once more. Turn the board over and repeat.

4.Re-measure the board and compare your results with the scale. If there is a discrepan- cy, loosen the scale adjustment screw and correct the position. See Figure 33.

Adjustment

Screw

Figure 33

NOTES

-28-	G1021 15" Planer

Image 28

Grizzly G1021 instruction manual Thickness Scale, To Adjust the Scale

Contents

Planer Page Table Of Contents Adjustment Block Pattern Warranty and Returns Safety Safety Instructions For Power Tools Safety Instructions For Power Tools Additional Safety Instructions For Planers Fusing Circuit Requirements220V Operation Grounding Extension Cords Introduction Commentary Unpacking Parts Inventory Clean Up Site Considerations Overview AssemblyOptional Stand Planer Unit Starter SwitchTo Mount the Planer To Assemble the Knife Setting JIG Handwheel Knife Setting JigTo Mount the Handwheel To Attach the Extension Rollers Extension Rollers Dust PortTo Attach the Dust Port Adjustments Overview of planer adjustment controls G1021 15 Planer Gauge Block Table AdjustmentTo Check Table Parallelism Knife Inspection To Inspect the Knives Knife Setting To SET the Knives To Adjust the Chipbreaker Chip Breaker Feed Roller Height To Check Roller Height To Adjust Roller Pressure To Adjust Roller HeightFeed Roller Pressure To Adjust the BED Rollers Bed Rollers To Adjust the Chip Deflector Chip Deflector To INSPECT/ADJUST the Pulleys Anti-KickbackBelts To Check Belt Tension GearboxTo Inspect the Gearbox Extension Rollers Extension Rollers To Adjust the Scale Thickness Scale Operations Table Locks Handwheel Power FeedDepth Limiter Test Run Wood Species Type Shear PSI Planing Difficulties Maintenance GeneralKnives Lubrication Fill Drain Adjustment Section Closure Troubleshooting Symptom Possible Cause Corrective Action Reference 145 79 80 146 See page 41-42 for Reference Number Listing See page 41-42 for Reference Number Listing Pulley Cover PK06M G1021 15 Planer Warranty and Returns