Grizzly G1021 instruction manual Operations, Table Locks

SECTION 6: Operations

WARNING

The Model G1021 15" Planer is a powerful woodworking machine, designed and con- structed for professional-quality applica- tions. Because of its powerful motor and razor-sharp knives, the Model G1021 is inherently dangerous and should be operat- ed with considerable caution and respect. Failure to do so could result in damage to the machine, or severe injury to the opera- tor or others in the work area.

Overview

In addition to the safety issues discussed earlier in this manual, there are a number of safety issues that relate directly to the operation of the planer. Keep in mind that these are not all-inclu- sive. Work situations, wood types, and other vari- ables that differ from shop to shop must be con- sidered in order to operate this planer safely. Always consider safety and common sense first when operating this or other machinery.

1.Always inspect lumber for defects (warping, cupping, twisting, etc.). Do not use lumber of questionable quality.

2.Check lumber for nails, staples, imbedded gravel, etc. before planing.

3.Use the full width of the planer. Alternate between the left, the right and the middle when feeding lumber into the planer. Your knives will remain sharp much longer.

4.Remove glues, epoxies and other foreign materials before planing lumber.

5.NEVER attempt to plane laminates, particle boards, plastics or other man-made materi- als.

6.Plane wood with the grain. NEVER plane end-grain lumber.

G1021 15" Planer

7.Do not use boards with loose knots, splits, crossgrain or other defects. They can dam- age the machine and cause injury.

8.Keep your work area clear.

9.Wood with more than 20% water content or wood exposed to rain, ice, or snow will plane poorly and cause excess wear to the knives and motor. Excessive moisture will also has- ten rust and corrosion.

10.Read as much as possible about planing procedures. Alternative publications present more wood specific planing requirements. They will often share tips on safety and more efficient ways to operate your planer.

Table Locks

Before attempting to adjust table height, loosen the two black knobs on the left side of the table. After table height is adjusted and the table height is set, tighten the two black knobs back down again. See Figure 34.

Figure 34. Table lock knob.

-29-