SECTION 4: ASSEMBLY
Overview
Most of your G1021 Planer has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.
TOOLS REQUIRED: Most of the tools required for assembly are included with the planer. However, you will also need a Phillips® and regu- lar screwdriver as well as feeler gauge for adjust- ments later on.
Figure 2. Stand crossbracing in place.
Optional Stand
To begin stand assembly, keep all the stand parts within easy reach. To ease assembly, build the stand upside down on a bench and then place it upright on the floor.
1.Place the stand top upside down on your bench.
2.Attach each of the four legs to the stand top with carriage bolts, washers and nuts provid- ed. Do not over tighten. The legs attach to the outside of the stand top. See Figure 3.
3.Attach each of the four braces to the stand legs with carriage bolts, washers and nuts provided. Do not over tighten. The braces attach to the inside of the legs. See Figure 2.
4.Flip the stand right side up and place on the floor. Check to see if the stand is symmetrical from two adjacent sides. Adjust if necessary and securely tighten all nuts.
Figure 3. Fully assembled stand.
G1021 15" Planer |
