Jam Nut |
Set Screw |
Figure 30. Roller height adjustment controls.
10.Using the same zeroed reference on the Rotacator, adjust the height of the chip break- er and outfeed roller to their given specifica- tions. The adjustment controls for each are shown in Figure 31.
Chip Breaker |
Adjustment |
Screw |
Chip Breaker |
Figure 31. Adjustment locations for the chip
breaker.
To adjust the height of the infeed and outfeed rollers, and the chip breaker using wood blocks and a feeler gauge:
1.Make the wood blocks by cutting a STRAIGHT 6' long 2x4 in half.
Note: Having the wood blocks at an even height is critical to the accuracy of your over- all adjustments. For best results, remove board warpage by squaring the narrow sides of the 2x4 with a jointer and table saw before cutting in half.
2.DISCONNECT THE PLANER FROM THE POWER SOURCE!
3.Lower the bed rollers below the table.
4.Place one wood block along the left side of the table, and place the other wood block along the right side of the table, as illustrated in Figure 32.
��� 
����������
Figure 32. Wood blocks on table.
5.Remove the dust port, top cover and belt cover.
6.Adjust the table and use the feeler gauge until you have a 0.040" gap between the edge of a carbide insert at bottom dead center (find by rocking cutterhead pulley) and the wood blocks.
G1021X 15" Extreme Series Planer |
