Grizzly G1024 Xiv. Equipment Maintenance, Xv. Closure, A. Lubrication, B. V-Beltmaintenance

XIV. EQUIPMENT MAINTENANCE

Your Model G1024 Shaper requires very little maintenance. A thorough cleaning, now and again, will increase the machine’s durability and efficiency, by removing dust and grime that can gum up mov- ing parts. Sharp cutting surfaces are essential for top performance. If you find that the machine cuts less efficiently than usual, inspect the cutters and repair or replace them as necessary. An occa- sional application of Top-Cote®protective spray will keep the shaper table and other bare metal parts from rusting and pitting. Remember: When performing maintenance or repairs on this, or other shop equipment, always disconnect the power supply.

A. LUBRICATION

The Model G1024 features factory-sealed bearings. A sealed bearing requires no lubrication during its lifetime.

Should a bearing fail, your shaper will probably develop a noticeable rumble, which will increase when the machine is put under load. If allowed to get worse, overheating of the journal containing the bad bearing could occur. If the bad bearing is not replaced, it will eventually seize – possibly doing damage to other parts of the machine. Bearings are standard sizes and can be replaced through Grizzly.

The only parts on this machine that require periodic lubrication are the ways where the cartridge slide rides on the elevation housing and where the worm gear and bushing are located. Use a light grease or anti-seizing compound on the ways and worm gear and give the shaft mount a shot of light oil. The frequency of lubrication depends on the amount you use the shaper. As a habit, inspect the machine at least one a month.

B. V-BELT MAINTENANCE

Avoid getting grease or oil on the V-belt or pulleys.

Check the V-belt, as part of your monthly inspection, for proper tension and belt condition. Cracking and glazing could result in belt failure. Replace the belt if such conditions appear.

XV. CLOSURE

The following pages contain the directory of parts for your Model G1024 Shaper. We have also included a wiring diagram and instructions for using the optional Router Bit Spindle for your conve- nience.

Please feel free to write or call us if you have any questions about the machine or the manual.

Thank you again for your business and continued support. We hope to serve you again soon.

- 27 -