4.With the provided washer, thread the ratchet handle through the miter gauge and into the table as shown in Figure 21.
Figure 21. Installing the ratchet handle.
5.Insert the the miter gauge pointer shown in Figure 22, but do not tighten the nearby setscrew at this time.
Figure 22. Installing the pointer.
6.Place flat washers on the miter fence hex bolts, then start the special nuts onto the ends. Slide the special nuts into the groove of the fence. The end piece for the fence works with the same special nut and hex bolt system. When these have all been installed on the miter fence, it is time to install the fence onto the miter gauge as in Figure 23.
Figure 23. Installing the miter fence.
7.Slide the clamping unit onto the push shaft as shown in Figure 24.
Figure 24. Installing the clamping unit.
G8621 |
