Guard |
| Fence Assembly |
|
|
|
|
|
|
|
|
|
|
|
|
To mount the cutter guard to the table:
1.Place the guard over the threaded holes on the table.
2.Insert the shaft guide into the guard as shown in Figure 12, and thread the shaft guide clockwise to secure the guard to the table.
Figure 12. Inserting shaft guide into guard.
Insert the adjustment guide into the screw brack- et. Line up the shaft groove shown in Figure 11 with the center bolt and screw the bolt into the groove as shown in Figure 13. Do not complete- ly tighten the bolt. This will allow the shaft to spin without coming out.
Figure 13. Tightening bolt into shaft groove.
To mount the fence brackets to the guard body:
1.Insert the adjustment shaft into the fence bracket as shown in Figure 14.
Figure 14. Adjustment guide to fence bracket.
2.Insert the adjustment handle (Figure 15) into the fence bracket, and thread it into the guard body.
Figure 15. Adjustment handle.
|
|
|
|
|
|
|
|
|
| G8621 | |
|
|
