Grizzly 9962ZX, G9962Z, G0582, G0445 instruction manual Recommended Adjustments

To start the machine:

1.Wear safety glasses and respirator at all times when running the machine!

2.Connect the machine to the power source.

3.Press the TABLE UP and TABLE DOWN keys. The table should go up and down smoothly.

Note: On 3-phase machines, make sure the table moves in the same direction as the but- ton description. If not, then the power needs to be disconnected and any two power wires need to be switched at the circuit breaker in the electrical box. If using a phase converter, switch the R and T wires.

4.Press the FEED BELT START and FEED BELT STOP buttons. The feed belt should start, run, and stop smoothly.

5.Press the SANDING BELT START and SANDING BELT STOP buttons. The sanding belt should start, run, and stop smoothly.

The machine should run smoothly, with little or no vibration or rubbing noises. Strange or unnatu- ral noises should be investigated and corrected before operating the machine further.

If the machine seems to be running correctly, let it run for a short time to ensure that the mov- ing parts are working properly with no excessive vibration. DO NOT operate the machine if prob- lems cannot be corrected.

If you cannot locate the source of unusual noises, refer to Troubleshooting, and feel free to con- tact our Technical Support Department at (570) 546-9663.

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and require no further adjustment. However, we rec- ommend that you verify that the adjustments are correct and to your satisfaction.

Recommended adjustment checklist: —Table Calibration, Page 28. —Feed Belt Tension, Page 38. —Feed Belt Tracking, Page 38. —Air System, Page 27. —Oscillation Timing, Page 30. —Oscillation Speed, Page 32. —Pressure Rollers, Page 33. —Table Parallelism, Page 32. —V-Belt Adjustment, Page 34.

-20- G0445/G0582/G9962Z/9962ZX Wide Belt Sander