Grizzly H3114 instruction manual To mount the router to the table, Method

To mount the router to the table:

The base plate mounting holes on some brands of routers may align with the router mounting holes on the main table. If the holes line up, con- tinue with Method 1. If the holes do not line up, skip ahead to Method 2.

Method 1

1.Remove the base plate from the router base by removing the three base plate screws. Note—The router base plate is usually a cir- cular black plastic plate that is screwed to the router base.

2.Turn the router upside down and hold the router base against the circular recess in the underside of the main table as shown in Figure 7.

Circular Recess

Figure 7. Router positioned correctly for

"Method 1" installation.

3.Rotate the router until the main table mount- ing holes align with the mounting holes in the router base. Note—Orient the router so the adjustment controls are easy to reach.

4.With the three screws removed in Step 1, secure the router to the underside of the main table.

Method 2

1.Remove the base plate from the router base. Note–The bottom face of the router base must form a continuous ring with no gaps. If the router base does not have this design, DO NOT remove the base plate.

2.Turn the router table upside down.

3.Insert the supplied M5-0.8 x 45 carriage bolts through the four large mounting holes in the top of the main table.

4.Slide the four clamps over the ends of the carriage bolts with the tabs facing the under- side of the main table as shown in Figure 8.

Clamps

Figure 8. Clamps for securing “Method 2” style

routers to the main table.

5.Begin threading the M5-0.8 keps nuts onto the ends of the M5-0.8 x 45 carriage bolts.

6.Rotate the clamps out of the circular recess and position the router base against the cir- cular recessed area.

-10- H3114 Router Table