Grizzly H3114 instruction manual Groove cutting setup Top View

Groove cutting:
Beading is commonly defined as cutting a groove		Distance From
or bead in the face of a board.		Edge Of Board
		To Center Of
1.	Mount a router bit into your router according	V-Groove
	to the router manufacturer’s instructions.
2.	Snap one of the table inserts into the
	recessed hole on the table. Use the insert
	with the smallest hole that still allows the bit
	free rotation.
3.	Raise the bit to the desired height.

4.Loosen the threaded knobs that secure the main fence.

5.Adjust the main fence until the center of the V-groove bit is the desired distance away as shown in Figure 21 & 22.

Distance From

Edge Of Board

To Center Of

V-Groove

Figure 21. Groove cutting setup.

(Top View)

Figure 22. Groove cutting setup.

(Side View)

6.Tighten the main fence threaded knobs.

7.Double check that the router is secured to the table. If it is, the router table is ready for use.

H3114 Router Table -15-