7.Hold the router and rotate the clamps over the router base as shown in Figure 9.
Clamp Position
Figure 9. Rotating a clamp over
the router base.
8.Tighten the M5-0.8 keps nuts enough to pre- vent the router from moving, but DO NOT fully tighten them at this time.
9.Turn the router table top-side up.
10.Loosen the M5-0.8 keps nuts several turns and reposition the router until the router spin- dle is centered in the round table cut-out when viewed from above.
11.Tighten the M5-0.8 keps nuts (Figure 10).
Figure 10. Correctly clamped router.
To assemble the fence:
1.Attach the spring to the retractable guard as shown in Figure 11.
Retractable Guard
Spring
Figure 11. Correct spring placement.
2.Insert the retractable guard into the fence and secure the guard with the supplied M4 x 12 tap screw and the M5 flat washer (Figure 12). The bit guard should move freely with no binding on the fence. If binding occurs, light- ly sand or file the contact areas.
Figure 12. Correctly installed guard.
H3114 Router Table |
