| Table Of Contents (continued) |
|
| Local Control Of Output Functions | 85 |
| General | 85 |
| Setting Voltage and Voltage Range | 86 |
| Setting Current and Current Range | 87 |
| Enabling/Disabling an Output | 87 |
| Setting Overvoltage Protection | 88 |
| Resetting Overvoltage Protection | 88 |
| Enabling/Disabling Overcurrent Protection | 88 |
| Resetting Overcurrent Protection | 88 |
| Local Control Of System Functions | 88 |
| Setting the Supply’s | 88 |
| Displaying Error Messages | 89 |
| Storing and Recalling Voltage and Current. Settings for all Outputs | 89 |
A | Alignment Procedures |
|
| Introduction | 91 |
| Test Equipment and Setup Required | 91 |
| Calibration Program | 91 |
| Alignment Program | 95 |
B | Programming With a Series 200/300 Computer |
|
| Introduction | 103 |
| I/O Path Names | 103 |
| Voltage and Current Programming | 103 |
| Voltage and Current Programming With Variables | 104 |
| Voltage and Current Readback | 104 |
| Programming Power Supply Registers | 105 |
| Present Status | 105 |
| Service Request and Serial Poll | 106 |
| Error Detection | 107 |
| Stored Operating States | 108 |
C | Command Summary |
|
| Introduction | 109 |
D | Error Messages |
|
| Introduction | 117 |
| 117 | |
| Error Responses | 117 |
| Test Responses | 117 |
E | Manual Backdating |
|
| Introduction | 121 |
| Make Changes.................…………………………………………………………………………………...121 |
|
| Agilent Sales and Support Office |
|
| Contacts | 122 |
9