Turning On Your Supply
The following paragraphs describe the
Before you turn on your supply, make sure that:
∙The line module on the rear panel is set to match your input line voltage.
∙The proper fuse is installed and the line cord is plugged in.
If you have any questions concerning installation or power requirements, review Chapter 2.
To turn on your supply, press the front panel LINE switch. When the power is initially applied, the supply performs a series of self tests which last about 3 seconds. Included in these tests are checks of circuits on the
Normal Self Test Indications
If the supply passes the self test, the display will first show all segments of the LCD display with annunciators on as illustrated in Figure
Figure 3-2. Test Pattern of all Display Segments at Power-on
After all segments are displayed, the supply’s
3.As shipped from the factory, the power supply’s address is set to 5. You must know this address before you can remotely program your supply.
Figure 3-3. Typical Address Display During Power-On Self Test
When self test is successfully completed, the
36Getting Started