4. Double check the the flushness of the work- ing surface with the straightedge.
-9-
Retighten the mounting screws.
3.
To check the flushness of the table:
1. Place a straightedge across both extension tables and the main table. The straightedge should sit flush on all three surfaces as shown in Figure 6.
Figure 6. Using a straightedge to ensure the
working surfaces are flush.
2. If either extension table is not flush with the main table, loosen the mounting screws and adjust the assembly until both extension tables and the main table are flush with one another.

3.Align one of the legs with the mounting holes on the inside edge of the main table as shown in Figure 4.

Figure 4. Aligning a leg with the main table.

4.Secure the leg and extension table to the main table with the supplied #10-32 x 34" truss head phillips screws and the #10-32 keps nuts as shown in Figure 5.

Figure 5. Securing a leg to the main table.

5.Repeat Steps 3 & 4 for the remaining three legs.

H3114 Router Table

Page 11
Image 11
Grizzly H3114 instruction manual