Grizzly H3372 instruction manual Starting, To start the air compressor

Figure 4. ON/OFF button.

2. Close the drain valve, shown in Figure 5, so the tank can build up pressure.

Figure 5. Drain valve location.

STARTING

To start the air compressor:		Check the pressure gauge to see that the
1.	Make sure the compressor switch is	tank pressure climbs to approximately 100-
		115 PSI or around 8 BAR, then automati-
	in the OFF position (knob with red	cally turns off.
	cap above pressure gauges shown
	in Figure 4 pressed down) before	NoteÑIf the compressor does not auto-
	connecting the power supply.	matically kick off, flip the ON/OFF switch to
		OFF before pressure gets too high. See
		the Pressure Regulator sub-section.

Operating this equipment has the potential for flying debris to cause eye injury. Always wear safety glass- es or goggles when operating equip- ment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).

3.Double check the oil level to make sure it is at the proper height.

4.Connect the compressor to the power supply.

5.Pull the switch up to the ON position to start compressor.

-8- H3372 3 HP Air Compressor