Lubrication
To prevent excessive wear on the saw blade, be sure to maintain a continuous flow of water on both sides of the blade. Never cut tile without the water lubrication system running.
To set up the water lube system:
1.Assemble the pump and hoses as described on Page 12.
2.Position the pump so it does not interfere with the movement of the table.
3.Fill the water reservoir with enough water to completely cover the suction inlet on the pump as shown in Figure 19. DO NOT over- fill the reservoir.
Figure 19. Filled water reservoir.
4.The pump turns on when the saw is turned on. The water flow can be adjusted using the flow rate lever on the side of the pump.
|
|
|
|
|
|
|
|
|
|
|
|
H3390 Wet Tile Saw | |||
