12.Slide the plastic rail end pieces over each of the table rail ends as shown in Figure 15.
Rail End Pieces
(1 of 2)
Figure 15. Installing the rail end pieces.
13.Attach the rail/table assembly to the saw frame, using (2) M14-2.0 x 35 hex bolts, (2) M14 flat washers, and (2) M14 external tooth washers as shown in Figure 16.
Figure 16. Attaching the rail/table assembly to
the saw frame.
Blade Changes
To change/install a blade:
1.Unplug the machine from the power source!
2.Loosen the lock knob on the side of the blade guard (Figure 11, Page 12).
3.Lift the blade guard to the up position and tighten the lock knob. The blade guard should remain in the up position.
4.Press the arbor lock pin (Figure 17) and rotate the arbor nut by hand until the arbor lock pin fully depresses.
5.Continue to hold the arbor lock pin and use an
!
Loosen
Figure 17. Loosening the arbor nut.
6.Remove the arbor nut and flange, and slide the blade onto the arbor.
7.Replace the flange onto the arbor and thread the arbor nut onto the arbor.
8.With the arbor lock pin still fully depressed, tighten the arbor nut using an open-end wrench.
9.Reposition the blade guard to the down posi- tion and tighten the knob loosened in Step 1.
|
|
|
|
|
|
|
|
|
|
|
|
H3390 Wet Tile Saw | |||
