Table |
|
Components and Hardware Needed: | Qty |
Sliding Table | 1 |
Table Brace | 1 |
Cover Plate | 1 |
Cap Screws | 2 |
Hex Nuts | 4 |
Hex Bolts | 4 |
Flat Washers 6mm | 4 |
Front Rail (w/Groove for Bearing) | 1 |
Rear Rail | 1 |
Carriage Bolts | 4 |
Acorn Nuts | 4 |
Tools Needed: | Qty |
Wrench or Socket 10mm | 2 |
To install the table: |
|
1.Place the cover plate on the saw unit as shown in Figure 11.
Figure 11. Cover plate in the correct position
with holes aligned.
2.Place the rear rail over the cover plate and align the mounting holes.
3.Secure the rear rail and cover plate to the saw body with two carriage bolts and acorn nuts. Note—The acorn nuts are meant to be mounted outside of the saw body, as shown in Figure 12.
Figure 12. Rear rail attached to saw body.
4.Install the front rail in the same manner as the rear rail.
5.Slide the table onto the rails so the table roll- ers roll freely along the rails.
6.Standing at the back of the saw, push the table forward as far as it will go.
7.Install the table brace on the back of the table, up underneath the table lip, and secure it with the four hex bolts and flat washers (Figure 13).
H6246 Meat Cutting Bandsaw |
